Ht-instruments HT5000 Manual de usuario descargar pdf (Pagina 25)

HT-5000

EN - 24

4.3.5 Functional test of the receiver

If problems or strange measuring results occur during a line location procedure, it may be

helpful to check the functionality of the receiver using the integrated self-test. This test may

provide information about possible malfunctions of the instrument. Preferably, the self-test

should be performed in an interference-free environment without live cables

Proceed as follows to perform a self-test:

Step Action

Switch off the receiver RX5000. The test can be started by pressing

and holding followed by for at least 3 seconds

If the self-test is successfully accessed, the display should show the

software and hardware versions of the receiver components:

Press the function key to start the self-test

If the test is successfully passed without any problems, the display

shows the following information:

If a fault is recognized during the test, the self-test procedure is

terminated and the display indicates the respective error code (see

next page):

If this is the case, the error code should be forwarded to the service

department of HT ITALIA

Press the function key to exit the self-test

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31

Sin comentarios

Ht-instruments HT5000 Manual de usuario Pagina 25